Incoming Quality Inspector

SLB; Klang City; On-site; MYR 33,000 - 47,000; Full time

Job summary

SLB is seeking a Technology Quality Technician to perform inspections, tests, and reporting to ensure compliance with specifications. You will document results, assist in test fixture design, and support calibration activities while adhering to safety and quality procedures.

As part of the Manufacturing System, you will contribute to continuous improvement by analyzing data, participating in risk assessments, and maintaining measurement system accuracy. A minimum diploma or higher is required.

Qualifications

• Describes quality control and inspection activities.
• Includes creation/review of test procedures and risk assessments.

Responsibilities

• Inspect documentation, parts, components, materials, subassemblies and equipment against specifications.
• Perform manufacturing and engineering tests per procedures.
• Assist in designing tests and fixtures and their setup.
• Ensure inspections and tests are conducted safely and contribute to Hazard Analysis and Risk Control.
• Calibrate measurement systems when authorized.
• Document results and verify stability over time.
• Drive continuous improvement using Manufacturing System principles.

Education

Diploma or higher

Job description

The Technology Quality Technician is responsible for conducting quality control activities, including inspections, tests and results reporting. The Technology Quality Technician combines practical skills with understanding of the overall Quality Management System and the impact of nonconformances on the performance of equipment and systems.

• Inspect documentation, parts, components, materials, subassemblies and equipment against stated specifications, using measurement systems with valid calibration and acceptable repeatability and reproducibility. Comply with applicable inspection procedures and standard work.
• Perform manufacturing and engineering tests in compliance with applicable procedures and standard work.
• Assist in designing tests and fixtures and their set-up.
• Ensure all inspection and test activities are conducted safely. Participate in creation and review of Hazard Analysis and Risk Control for these activities.
• When authorized, perform calibration of measurement systems.
• Be familiar with inspection and test procedures, standard work and test plans, and provide input to continuously improve them.
• Document the results of inspections and tests. Verify the stability of results over time, as feasible.
• Use the guiding principles and tools of the Manufacturing System to drive continuous improvement, wherever applicable.

Min diploma and above