Avionics & Embedded Systems Engineer

Meditab India

Ahmedabad

Sur place

INR 1 200 000 - 2 500 000

Plein temps

Il y a 45 heures
Soyez parmi les premiers à postuler

Une candidature complète en une minute

Un CV et une lettre de motivation personnalisés, prêts à envoyer.

Passez les filtres ATS

Résumé du poste

Meditab India is seeking an hands-on Avionics & Embedded Systems Engineer to lead aircraft electrical and avionics integration for a fixed-wing aircraft project. You will install and interface avionics, instrumentation, sensors and power systems, while developing embedded firmware and ensuring safety-critical software practices.

You will collaborate with mechanical, structural, aerodynamic and manufacturing teams through design, prototype assembly, ground testing and flight testing, shaping the

Qualifications

  • Bachelor's degree in Electronics Engineering, Electrical Engineering, Avionics Engineering, Embedded Systems or a related discipline.
  • Approximately 3-4 years of relevant engineering experience, preferably in aerospace, UAVs, avionics, industrial control or other safety-critical embedded systems.
  • Strong understanding of electronic circuits, sensors, power systems and electrical interfaces.
  • Practical experience developing embedded firmware in C/C++.
  • Experience with microcontrollers such as STM32, NXP, Microchip or equivalent.
  • Familiarity with CAN, UART, SPI, I2C and analogue sensor interfaces.
  • Ability to read and develop electrical schematics and wiring diagrams.
  • Experience using oscilloscopes, multimeters, logic analysers and other electronic test equipment.
  • Strong troubleshooting and technical documentation skills.

Responsabilités

  • Integrate avionics into the aircraft and develop installation drawings.
  • Design avionics architecture and interface control documents.
  • Develop embedded firmware for monitoring interfaces using Embedded C/C++.
  • Implement CAN/UART/SPI/I2C communications.
  • Perform electrical load analysis and power-budget assessments.
  • Coordinate with engine sensors and ESI integration.
  • Support avionics installation, ground tests and flight-test instrumentation.

Connaissances

Embedded firmware development (C/C++)
STM32 / NXP / Microchip MCUs
CAN / UART / SPI / I2C interfaces
Electrical schematics / wiring Diagr
Diagnostics & test equipment

Formation

Bachelor's degree in Electronics / Electrical / Avionics / Embedded Systems

Outils

Altium Designer
KiCad

Description du poste

Employment Type: Full-time

Experience: 3-4 years preferred

About the Role

We are developing a new fixed-wing, twin-turboprop aircraft featuring pusher propellers and an integrated digital avionics architecture. We are seeking a hands-on Avionics & Embedded Systems Engineer to lead aircraft electrical and avionics integration, including the installation and interfacing of commercially available avionics equipment, engine instrumentation, sensors, electrical power systems and flight-control-related electronics.

The role includes developing embedded firmware for aircraft-specific interfaces, monitoring functions and supporting electronics where required.

The successful candidate will work closely with mechanical, structural, aerodynamic and manufacturing engineers from design through prototype assembly, ground testing and flight testing.

Key Responsibilities:
  • Integrate commercially available avionics, including Microair equipment, into the aircraft.
  • Develop avionics architecture, system block diagrams, interface control documents and installation drawings.
  • Integrate displays, air-data systems, engine instrumentation and communication/navigation equipment.
  • Develop interfaces between avionics equipment, sensors and other aircraft systems.
  • Support autopilot integration, including electrical and electronic interfaces, with appropriate flight-control safety verification.
2. Aircraft Electrical Systems
  • Design aircraft electrical power distribution and protection systems.
  • Develop wiring diagrams, cable schedules, connector pinouts and harness installation documentation.
  • Perform electrical load analysis, voltage-drop calculations and power-budget assessments.
  • Specify connectors, circuit protection, wiring, grounding and bonding arrangements.
  • Support electromagnetic compatibility and interference assessments.
3. Embedded Firmware Development
  • Develop and maintain embedded firmware for aircraft-specific monitoring and interface applications.
  • Program microcontrollers using Embedded C/C++.
  • Interface with sensors, analogue and digital inputs, and communication buses.
  • Develop data acquisition, signal conditioning, monitoring and diagnostic functions.
  • Implement communication protocols such as CAN, UART, SPI and I2C.
  • Develop firmware test procedures, debugging tools and configuration documentation.
  • Apply appropriate software verification, traceability and configuration-control practices, especially for functions affecting flight safety.
4. Engine Instrumentation and Sensor Integration
  • Integrate engine sensors and Engine Sensor Interface (ESI) equipment.
  • Develop interfaces for engine parameters such as temperature, pressure, RPM and other manufacturer-specified measurements.
  • Verify signal compatibility, scaling, calibration and data integrity.
  • Coordinate with the engine supplier to ensure compliance with installation and interface requirements.
5. Prototype Assembly and Testing
  • Support avionics and electrical equipment installation into the aircraft.
  • Supervise wiring harness fabrication, installation and inspection.
  • Develop and execute bench tests, hardware-in-the-loop tests where appropriate, and aircraft ground-test procedures.
  • Troubleshoot electrical, electronic and firmware-related faults.
  • Support integration testing, engine ground runs and flight-test instrumentation.
  • Record test results, nonconformances and corrective actions.
6. Engineering Documentation and Compliance
  • Prepare electrical and avionics design reports, installation instructions and verification documentation.
  • Maintain equipment lists, wiring diagrams, interface specifications and firmware revision records.
  • Support DGCA documentation, aircraft-level safety assessments and compliance activities.
  • Work with applicable aviation standards and accepted means of compliance.
Required Qualifications:
  • Bachelor's degree in Electronics Engineering, Electrical Engineering, Avionics Engineering, Embedded Systems or a related discipline.
  • Approximately 3-4 years of relevant engineering experience, preferably in aerospace, UAVs, avionics, industrial control or other safety-critical embedded systems.
  • Strong understanding of electronic circuits, sensors, power systems and electrical interfaces.
  • Practical experience developing embedded firmware in C/C++.
  • Experience with microcontrollers such as STM32, NXP, Microchip or equivalent.
  • Familiarity with CAN, UART, SPI, I2C and analogue sensor interfaces.
  • Ability to read and develop electrical schematics and wiring diagrams.
  • Experience using oscilloscopes, multimeters, logic analysers and other electronic test equipment.
  • Strong troubleshooting and technical documentation skills.
Preferred Qualifications:
  • Experience with aircraft avionics integration or aircraft electrical system design.
  • Familiarity with Microair or comparable avionics systems.
  • Experience with engine instrumentation and sensor interface modules.
  • Knowledge of ARINC 429, CAN Aerospace or other aviation communication protocols.
  • Familiarity with RTCA DO-160, DO-178C and DO-254 principles.
  • Experience with PCB design tools such as Altium Designer or KiCad.
  • Experience with Python for test automation and data analysis.
  • Familiarity with autopilot systems, flight-test instrumentation or hardware-in-the-loop testing.
  • Experience supporting aircraft certification, prototype development or regulatory compliance.
  • The engineer will be responsible for producing:
  • Aircraft electrical and avionics architecture.
  • Electrical load analysis and power distribution design.
  • Avionics interface control documents.
  • Wiring schematics, connector pinouts and harness drawings.
  • Engine sensor and ESI integration documentation.
  • Embedded firmware and associated test records where required.
  • Avionics installation and inspection instructions.
  • Electrical and avionics verification procedures and reports.
  • Configuration-controlled technical documentation supporting aircraft flight-test readiness.
Ideal Candidate:

We are looking for a practical engineer who enjoys working directly with hardware, understands embedded firmware, and can take ownership of aircraft electrical and avionics integration from initial design through prototype testing.

The ideal candidate combines strong electronics fundamentals, embedded programming capability, disciplined engineering documentation and a hands-on problem-solving approach.

Obtenez votre examen gratuit et confidentiel de votre CV.

ou faites glisser et déposez votre fichier ici.

Similar jobs

Postes similaires à comparer

Aircraft Integration Imagineer – Electrical, Avionics & Battery Systems
Aircraft Integration Imagineer – Electrical, Avionics & Battery Systems

Ubifly Technologies Pvt Ltd • Kelambakkam

Sur place
INR 1 200 000 - 1 800 000
Aircraft Integration Imagineer – Electrical, Avionics & Battery Systems
Aircraft Integration Imagineer – Electrical, Avionics & Battery Systems

Ubifly Technologies • Kelambakkam

Sur place
INR 1 300 000 - 1 800 000
None
Associate Scientist - Avionics Engineer
Associate Scientist - Avionics Engineer

Dreamaerospace Technologies Pvt. Ltd. • Kanpur

Sur place
INR 600 000 - 1 000 000
Aircraft Integration Imagineer – Electrical, Avionics & Battery Systems
Aircraft Integration Imagineer – Electrical, Avionics & Battery Systems

The ePlane Company • Chennai

Sur place
INR 1 800 000 - 2 400 000
UAV Systems Engineer
UAV Systems Engineer

Haass • Karnataka

Sur place
INR 800 000 - 1 200 000
J_1322 - Electrical Systems Integration Engineer (Aerospace/UAV)
J_1322 - Electrical Systems Integration Engineer (Aerospace/UAV)

Mployee.me • Pune District

Sur place
INR 1 200 000 - 2 500 000
System Engineer
System Engineer

EndureAir Systems Pvt Ltd • Dadri

À distance
INR 700 000 - 1 200 000
Senior Engineer, Electrical Systems & Integration
Senior Engineer, Electrical Systems & Integration

IdeaForge • Navi Mumbai

Sur place
INR 2 500 000 - 4 200 000
Engineer II - Avionics
Engineer II - Avionics

NewSpace Research and Technologies • Bengaluru

Sur place
INR 600 000 - 1 200 000
Associate Scientist - Avionics Engineer
Associate Scientist - Avionics Engineer

Dream Aerospace • Kanpur

Sur place
INR 600 000 - 900 000