Welders

Feldmeier Equipment, Inc.; City of Little Falls (NY); On-site; USD 30,000 - 43,000; Full time

Job summary

Feldmeier Equipment, Inc. seeks a Welder/Fabricator in Little Falls, NY. The role involves welding stainless steel using TIG, MIG, and spot welds, interpreting blueprints, and laying out components as needed.

Responsibilities include setting up equipment, maintaining safety standards, and logging work hours in the MES system. The job is full-time with a non-exempt classification and reports to the Floor Supervisor.

Qualifications

• Boces welding certificate or 6 months of welding experience.
• Previous fabricating experience.
• Ability to read measuring tapes and operate tools- grinder, and welding torch.

Responsibilities

• Comply with Feldmeier safety policies and OH&S regulations.
• Weld stainless steel using TIG, spot, and MIG techniques.
• Interpret blueprints and measurements to plan layouts.
• Layout component locations per instructions.
• Prepare work surface by cutting and finishing.
• Weld components in flat, vertical, and overhead positions.
• Set up and operate equipment for assigned jobs.
• Complete housekeeping duties and log time into MES system.

Skills

TIG welding

MIG welding

Spot welding

Blueprint interpretation

Reading tape measures

Education

Boces welding certificate

Tools

Grinder

Welding torch

Job description

Job Summary

Welders are the primary constructors of vessels at Feldmeier Equipment. The Welder position is quite varied regarding the scope of work performed.

• NY1688983
• Welder
• Little Falls, NY
• Job Type: Full-time
• Job Title: Welder/ Fabricator
• Reports To: Floor Supervisor
• Classification: Non-exempt
• Pay Range: $22.00-$31.50hr

Workers who are designated as Welder may also be tasked with other general work tasks not specifically covered under the Welder job description.

Tasks may include the following but are not limited to; as job duties may change throughout day depending on the workload.

Essential Functions Of Position

• Comply with all Feldmeier safety and Company policies and Occupational Health and Safety Regulations.
• Ability to TIG weld, spot weld and MIG weld stainless steel.
• Interpret blueprints, drawings, and measurements to plan layouts.
• Layout component locations per instructions.
• Prepare work surface via cutting and finishing.
• Weld small and large components in flat, vertical, and overhead positions via appropriate welding technique.
• Set up and operate equipment for assigned jobs.
• Complete housekeeping duties in assigned area or as requested by management.
• Complete all required paperwork and properly log time into the MES system, logging on and off.

Minimum Qualifications

• Boces welding certificate or 6 months of welding experience
• Previous fabricating experience
• Ability to read measuring tapes and operate tools- grinder, and welding torch.

Preferred Qualifications

• 2 or more years of TIG experience
• Experience welding with different Alloys
• Proficiently weld in flat, vertical and overhead positions

Physical Requirements

• Ability to stand and/or walk for up to 8 hours per day.
• Continual use of hands; pushing, pulling, grasp, hold, move, and maintain 20 pounds constantly with full range of motion, including above head, below feet and side to side.
• Occasional lifting, carrying, and maneuvering up to 50 pounds.
• Ability to climb ladders, stairs, and platforms for elevated work.
• Walking, bending, squatting, kneeling, balancing, stooping, lie down inside or under vessel and twisting while performing required job tasks.