Welders

Feldmeier Equipment, Inc.; City of Little Falls (NY); On-site; USD 30,000 - 43,000; Full time

Job summary

Feldmeier Equipment, Inc. in Little Falls, NY is seeking a Welder/Fabricator to join our manufacturing team. Welders will primarily construct vessels and perform varied tasks across the shop, including TIG, spot and MIG welding of stainless steel.

Responsibilities include interpreting drawings, laying out components, and preparing surfaces. You will also set up equipment, log time, and maintain a clean work area in a non-exempt, full-time role.

Qualifications

• Boces welding certificate or 6 months welding experience.
• Previous fabrication experience.
• Ability to read measuring tapes and operate grinder and welding torch.

Responsibilities

• Comply with Feldmeier safety and company policies.
• Weld stainless steel using TIG, spot and MIG as required.
• Interpret blueprints, drawings and measurements for layouts.
• Layout component locations per instructions.
• Prepare work surface by cutting and finishing.
• Weld components in flat, vertical and overhead positions.
• Set up and operate equipment for assigned jobs.
• Log time into MES system accurately.
• Perform housekeeping in assigned area as needed.

Skills

Measuring tapes

Fabrication experience

Torch welding

Education

Boces welding certificate

Tools

Grinder

Welding torch

Job description

Job Summary

Welders are the primary constructors of vessels at Feldmeier Equipment. The Welder position is quite varied regarding the scope of work performed.

Job Details

• NY1730175
• Welder
• Little Falls, NY
• Job Type: Full-time
• Job Title: Welder/ Fabricator
• Reports To: Floor Supervisor
• Classification: Non-exempt
• Pay Range: $22.00-$31.50hr

Workers who are designated as Welder may also be tasked with other general work tasks not specifically covered under the Welder job description.

Essential Functions Of Position

• Comply with all Feldmeier safety and Company policies and Occupational Health and Safety Regulations.
• Ability to TIG weld, spot weld and MIG weld stainless steel.
• Interpret blueprints, drawings, and measurements to plan layouts.
• Layout component locations per instructions.
• Prepare work surface via cutting and finishing.
• Weld small and large components in flat, vertical, and overhead positions via appropriate welding technique.
• Set up and operate equipment for assigned jobs.
• Complete housekeeping duties in assigned area or as requested by management.
• Complete all required paperwork and properly log time into the MES system, logging on and off.

Minimum Qualifications

• Boces welding certificate or 6 months of welding experience
• Previous fabricating experience
• Ability to read measuring tapes and operate tools- grinder, and welding torch.

Preferred Qualifications

• 2 or more years of TIG experience
• Experience welding with different Alloys
• Proficiently weld in flat, vertical and overhead positions

Physical Requirements

• Ability to stand and/or walk for up to 8 hours per day.
• Continual use of hands; pushing, pulling, grasp, hold, move, and maintain 20 pounds constantly with full range of motion, including above head, below feet and side to side.
• Occasional lifting, carrying, and maneuvering up to 50 pounds.
• Ability to climb ladders, stairs, and platforms for elevated work.
• Walking, bending, squatting, kneeling, balancing, stooping, lie down inside or under vessel and twisting while performing required job tasks.