LTO Material Handler

Engineered Floors; Dalton (GA); On-site; USD 17,000 - 25,000; Full time

Job summary

Engineered Floors in Dalton, GA is seeking team members for general warehouse roles focused on material handling and safety. The position requires lifting 25 lb carpet cores up to 30 times per shift, standing for about an hour, and occasional bending, reaching, and stooping as part of daily tasks.

Applicants should have a high school diploma or equivalent, basic math and reading/writing abilities, and familiarity with data entry.

Qualifications

• High school diploma or equivalent preferred.
• Must be able to read, write and perform basic arithmetic.
• Computer knowledge or data entry skills required.

Responsibilities

• Load and move carpet cores safely.
• Operate a lift truck.
• Use hand scissors as needed.
• Maintain quality and safety of own output.
• Report accidents and safety concerns.

Skills

Reading & writing

Basic math

Data entry

Education

High school diploma

Job description

Current job opportunities are posted here as they become available.

Performance Expectations (if applicable):

• Lifting is required of carpet cores weighing approximately 25 lbs. 30 times per shift.
• Standing is required approximately 1 hour per shift.
• Reaching is required for hand held computer approximately 75 times per shift.
• Stooping is required 10 times per shift for intervals of approximately 5 minutes.
• Bending is required for cores approximately 30 times per shift.
• Must be able to operate lift truck.
• Must be able to use scissors

Experience/Education Requirements:

• High school diploma or equivalent preferred.
• Must be able to read and write and do basic addition, subtraction, division, and multiplication.
• Computer knowledge or data entry skills are a necessary part of the job.

Other Requirements:

• Overtime is required on occasion.
• All accidents must be reported immediately.
• Perform any other duties as assigned.
• Safety equipment must be worn as required and requirements must be followed for all areas.
• Report to management any quality, safety, or potential problems encountered while performing the job.
• Responsible for quality and safety of his/her own output.