Industrial Electrician – 2nd Shift: Motors, Controls & PM

Snapon; Milwaukee (WI); On-site; USD 60,000 - 61,000; Full time

Job summary

Snap-on is seeking an experienced Industrial Electrician for the 2nd shift (2:00pm-10:00pm) at our Milwaukee facility to maintain and upgrade electrical systems.

You will read prints, analyze circuitry, service motors up to 50 HP, install conduit, and support preventive maintenance in a fast-paced plant environment.

This role requires NEC knowledge, lockout/tagout practices, climbing in overhead areas, and the ability to work in tight spaces; you may be asked to take an electrician test.

Qualifications

• 4 years of industrial electrical maintenance experience.
• Knowledge of safe electrical practices for grounding, lockout/tagout, de-energizing, testing and disabling electrical circuits to prevent injury to self and other persons.
• Knowledge of National Electric Code.
• Ability to climb in overhead structures, to work beneath machines and in close quarters performing analysis and repair work.
• Must be prepared to take an Electrician test.
• Preferred: Approved State Journeyman Electrician apprenticeship and active card.

Responsibilities

• Work with prints and drawings to analyze circuitry problems.
• Disconnect, replace, and reconnect electric motors from fractional HP up to 50 HP.
• Install conduit for equipment installation and replacement, may involve ladders and lift platforms.
• Redesign and engineer changes in machinery.
• Check, analyze, and repair hydraulic and pneumatic systems.
• Hazardous Duty work.
• Preventive maintenance work and plant facility upkeep.

Skills

Electrical maintenance

Read schematics

Code compliance

Troubleshooting

Lockout/tagout

Safety awareness

Education

Journeyman Electrician

Job description

Snap-on is seeking an experienced Industrial Electrician for the 2nd shift (2:00pm-10:00pm) at our Milwaukee facility to maintain and upgrade electrical systems.

You will read prints, analyze circuitry, service motors up to 50 HP, install conduit, and support preventive maintenance in a fast-paced plant environment.

This role requires NEC knowledge, lockout/tagout practices, climbing in overhead areas, and the ability to work in tight spaces; you may be asked to take an electrician test.