DRILLING OPERATOR - Third Shift Overnights

American Standard Circuits, Inc.; Chicago, Northern (IL, KY); Hybrid; USD 36,000 - 48,000; Full time

Job summary

American Standard Circuits, Inc. is seeking a machine operator for the 3rd shift to run panel board drilling and routing processes. Training may occur on the 1st or 2nd shift during the initial 4–6 weeks.

The role requires standing for long periods, ability to handle tools and materials, and adherence to safety and quality standards. Typical hours are 10:30 p.m. to 7:00 a.m., Monday through Friday, with overtime often available during the week.

Qualifications

• High school diploma is required.

Responsibilities

• Position panels on machine table, flush and aligned with tooling holes, start operation and remove boards at the end of the cycle.
• Check processed parts against template.
• Check tool sizes, remove and replace reset tools in magazine. Replace broken tools as required.
• Obtain and put away drills, mark drills that need to be re-sharpened.
• Notify supervisor of unusual equipment or operating difficulties.

Education

High school diploma

Job description

3rd Shift runs from 10:30 p.m. - 7:00 a.m., Monday - Friday. Overtime will often be available during the week. Training may take place on 1st or 2nd shift for the first 4 - 6 weeks.

SUMMARY OF FUNCTIONS

Actively involved in all duties for procedures related to operate machines to drill and/or rout panel boards.

ESSENTIAL DUTIES AND RESPONSIBILITIES

• Position panels on machine table, flush and aligned with tooling holes, start operation and remove boards at the end of the cycle.
• Check processed parts against template.
• Check tool sizes, remove and replace reset tools in magazine. Replace broken tools as required.
• Obtain and put away drills, mark drills that need to be re-sharpened.
• Notify supervisor of unusual equipment or operating difficulties.

QUALIFICATIONS

A high school diploma is required.

PHYSICAL DEMANDS

Standing for long periods of time is required.

Exertion of up to 50 lbs. of force occasionally may be required. Good manual dexterity for the use of common office equipment such as computer terminals, calculator, copiers, and FAX machines.

Use of small drill bits; dexterity required.

WORK ENVIRONMENT

This position is in a manufacturing setting with exposure to noise, dirt and chemicals.

WORK SCHEDULE

Training may take place on one of three shift for the first 4 - 6 weeks based on performance:

1st shift training: 7:00 a.m. - 3:30 p.m.

Mid shift training: 11:00 a.m. - 7:30 p.m.

2nd shift training: 3:15 p.m. - 11:45 p.m.

Permanent schedule would be 10:30 p.m. - 7:00 a.m., Monday - Friday with some overtime available during the week.