A complete application in a minute
Tailored resume and cover letter, ready to send.
American Standard Circuits, Inc. is seeking a manufacturing operator to set up and run drilling and routing machines for panel boards. You will position panels, check alignment, and ensure quality during each cycle.
The role requires standing for long periods, dexterity with small drill bits, and the ability to lift up to 50 lbs. Training is provided first shift or mid-shift for 4–6 weeks, after which the permanent schedule is 3:15 p.m. to 11:45 p.m., Monday–Friday, with overtime.
Description
2nd Shift runs from 3:15 p.m. - 11:45 p.m., Monday - Friday. Overtime will often be available during the week. Training may take place on 1st shift or mid-shift for the first 4 - 6 weeks.
Actively involved in all duties for procedures related to operate machines to drill and/or rout panel boards.
A high school diploma is required.
Standing for long periods of time is required.
Exertion of up to 50 lbs. of force occasionally may be required. Good manual dexterity for the use of common office equipment such as computer terminals, calculator, copiers, and FAX machines.
Use of small drill bits; dexterity required.
This position is in a manufacturing setting with exposure to noise, dirt and chemicals.
Training may take place on one of three shift for the first 4 - 6 weeks based on performance:
1st shift training: 7:00 a.m. - 3:30 p.m.
Mid shift training: 11:00 a.m. - 7:30 p.m.
Permanent schedule would be 3:15 p.m. - 11:45 p.m., Monday - Friday with some overtime available during the week.