Boilermaker: Weld, Fabrication & Rigging Specialist

Fluor Corporation; Jacksonville (TX); On-site; USD 55,000 - 95,000; Full time

Job summary

Fluor Corporation is seeking a skilled craft worker to support rigging, welding, and inspection activities across project sites in Texas and Jacksonville. The role involves following health, safety, and environmental requirements, performing material handling, cutting, fabrication, and alignment tasks, and reading blueprints to determine work scope.

Physical demands and environmental conditions are expected in this on-site position.

Responsibilities

• Follow all health, safety, and environmental requirements
• Perform cleanup duties
• Perform material handling and storage duties
• Identify, use, and care of common hand and power tools
• Use and care of craft specific tools and equipment
• Knowledge and application of craft related mathematics
• Knowledge and use of safety standards and best safety practices relevant to rigging, inspection of rigging equipment and hardware
• Knowledge and application of common hitches, emergency stop signal, basic crane hand signals, knot tying (bowline & clove hitch), and use of rigging equipment relevant to craft specific tasks
• Performs basic procedures for using various slings in hitches and calculating sling stress. Utilize tools and equipment used for the lateral movement of loads without a crane. Knowledge of wire rope components and inspection requirements and procedures for wire rope, load blocks, and sheaves
• Perform oxyfuel cutting operations
• Fabricate and install gaskets
• Identify and select pipe fittings
• Perform material cutting operations
• Perform bolt make-up
• Perform weld preparation and set-up
• Perform layout and fabrication duties
• Structural and tube fit-up and alignment
• Perform base metal preparation
• Perform preheat and post-weld heat treatment operations
• Perform vessel inspection
• Install valves and components
• Identify, fabricate and install pipe hangers and supports
• Fabricate and install stairs, railings, grating, and decking
• Review construction drawings and blueprints for specifications to determine work requirements
• Cut and thread pipe manually
• Read and interpret welding detail drawings
• Perform boiler tube fabrication, preparation, and fitting
• Perform air carbon arc cutting and gouging

Job description

Fluor Corporation is seeking a skilled craft worker to support rigging, welding, and inspection activities across project sites in Texas and Jacksonville. The role involves following health, safety, and environmental requirements, performing material handling, cutting, fabrication, and alignment tasks, and reading blueprints to determine work scope.

Physical demands and environmental conditions are expected in this on-site position.