Electronics & Firmware Engineer: Design, Debug & Innovate

STAR CAREER CONSULTING PTE. LTD.; Singapore; On-site; SGD 60,000 - 100,000; Full time

Job summary

STAR CAREER CONSULTING PTE. LTD. in Singapore seeks an Electronics & Firmware Engineer to design and develop equipment/testers, and to troubleshoot at the component level.

You will work on documentation, test plans, procedures, manuals, and contribute to failure investigations, using LabVIEW or C, RF knowledge, FPGA/CPLD is a plus, with a readiness to learn new software.

Qualifications

• Good knowledge in Electronics and Firmware.
• Programming knowledge in microcontrollers and circuit design; knowledge of FPGA and CPLD circuit design is an advantage
• Good in handling LabVIEW or C Programming.
• Good knowledge of Radio Frequency systems.
• Degree in Electronics Engineering or Diploma with minimum 7 years of experience in electronic design and troubleshooting
• Experience in using test instruments such as spectrum analyzers, signal generators, and digital oscilloscopes
• Basic soldering skills are required
• Willingness to learn new software and explore troubleshooting methodologies
• Singaporeans only

Responsibilities

• Responsible for the design and development of equipment/testers
• Perform equipment/module fault troubleshooting down to component level
• Involved in documentation, including test plans, procedures, and manuals
• Participate in failure investigations and assist in generating reports

Skills

Electronics knowledge

Firmware knowledge

Microcontrollers programming

RF systems knowledge

Soldering skills

Education

Electronics Engineering degree or Diploma with 7+ years experience

Tools

LabVIEW

C Programming

FPGA/CPLD design

Spectrum Analyzers

Signal Generators

Digital Oscilloscopes

Soldering tools

Job description

STAR CAREER CONSULTING PTE. LTD. in Singapore seeks an Electronics & Firmware Engineer to design and develop equipment/testers, and to troubleshoot at the component level.

You will work on documentation, test plans, procedures, manuals, and contribute to failure investigations, using LabVIEW or C, RF knowledge, FPGA/CPLD is a plus, with a readiness to learn new software.