Get a reply from this employer
Your resume and cover letter, tailored to exactly what they’re hiring for.
Green Line Human Resource & Trade Test Center (Overseas Projects) seeks an Injection Molding Worker to operate and monitor plastic injection molding machines in a public sector manufacturing environment. You will ensure products meet quality standards and safety guidelines while handling mold changes and parameter adjustments.
You will set up molds, optimize process settings, perform in-process inspections, and maintain production logs.
The Injection Molding Worker serves as a skilled machine operator within the production floor of a public sector industrial establishment. The role exists to ensure the continuous, efficient, and safe operation of injection molding machines for manufacturing plastic components meeting prescribed dimensional and quality standards. The incumbent is responsible for the complete machine cycle from mold installation and parameter setting to part ejection, inspection, and basic troubleshooting, directly contributing to the organization's production targets and asset utilization.
Daily workflow involves interpreting production job cards, selecting and drying raw material grades (PP, HDPE, ABS, etc.), and configuring machine parameters — injection pressure, holding pressure, screw speed, barrel temperatures, and cycle timers — via the machine control panel (HMI). The worker performs mold changes using overhead cranes/hoists, aligns ejector systems, and connects cooling water circuits. In-process quality checks are conducted using vernier calipers, go/no-go gauges, and visual inspection charts per approved control plans. All output, scrap rates, material consumption, and machine downtime are recorded in shift production registers and entered into the factory management information system (MIS). Career progression follows the departmental promotion channel to Senior Operator, Leading Hand, and Foreman upon passing prescribed trade tests and seniority requirements.
Selection for this Category B post is conducted strictly through a Practical Skill/Trade Test and a Direct Interview (Viva Voce); no written examination is administered. Candidates are evaluated on a live injection molding machine where they must demonstrate mold setup, parameter optimization for a given sample, production of conforming parts, and identification of induced faults. The oral viva voce assesses technical knowledge of molding principles, material behavior, safety protocols, and situational judgment on the shop floor.
Key duties and responsibilities: